(Note)
*1: Series O is inch-dimensioned.
*2: Series TAM . TG is extra-small and miniature.
1. The design of Thrust Ball Bearing may not be subjected to any radial load.
2. Thrust Ball Bearings are not suitable for high-speed rotation since lubricant is expelled by centrifugal force.
3. When used on a horizontal shaft. a minimum axial load must be applied.
Care must be taken in handling to prevent damage to the separable rings and ball assembly.
1. Ball Thrust Bearings should use close to the radial bearing. in order to prevent the effect of shafts deflection.
2. When using big size ball bearings on a horizontal shaft. preload should be implemented to prevent the clearance between housing washer and balls.
3. Under the inevitable circumstances of shaft deflection and misalignment, aligning seat washer should be applied.
Copyright © 2025 Nachi-fujikoshi corp. All Rights Reserved.
Copyright © 2025 Nachi-fujikoshi corp. All Rights Reserved.